0.373 inches minimum and 0.382 inches maximum hole diameter, 4.940 inches minimum and 5.060 inches maximum overall length, 1.440 inches minimum and 1.560 inches maximum overall width, 4.240 inches minimum and 4.260 inches maximum center to center distance between bolt holes along length, 0.375 inches nominal outside edge to bolt hole center distance along length, 0.750 inches nominal bolt hole centerline to nearest edge distance

A thin flat metal or plastic item of various peripheral shapes having a solid or laminated cross-section. It is designed to maintain a predetermined distance between two surfaces. For round items without a hole and having a solid rectangular cross-section use disk, solid, plain. Items with either (1) a solid (not laminated) cross-section, or (2) a non-separable laminated cross-section with one hole centrally located, must have a thickness less than 0.006 inch (0.152 mm) for items less than 1/4 inch (6.35 mm) outside diameter or shortest distance across peripheral flats, and less than 0.016 inch (0.406 mm) for items 1/4 inch (6.35 mm) or more outside diameter, or shortest distance across peripheral flats. For items with thickness greater than those indicated above, see spacer, plate; washer, flat and spacer, ring. When thickness and/or outside diameter or shortest distance across peripheral flats is designated as a tolerance dimension, the maximum dimension will be used to determine compliance. See also shim stock, laminated; shim stock assortment, gasket; and bearing, washer, thrust.